Steca Solarix MPPT is a solar charge controller with Maximum Power Point Tracking. It is specially designed to work with all established module technologies and is optimized for solar systems with module voltages higher than the battery voltage. The Steca Solarix MPPT is especially qualified in combination with grid tied solar modules.
The advanced MPP-tracking algorithm from Steca assures that the maximum available power of the solar generator is charged to the batteries. The Steca Solarix MPPT with latest technology ensures full performance in all conditions, a professional battery care combined with modern design and excellent protection.
Product No. R1039 Characterisation of the operating performance: System voltage 12 V (24 V) Nominal power 125 W (250 W) Max. DC-DC efficiency 98.3 % (Ubatt=24 V; Uin=30 V; P=0.6*Pnom) European efficiency 94.7 % (Ubatt=12 V; Uin=30 V); 96.7 % (Ubatt=24 V; Uin=30 V) European efficiency (weighted across all Ubatt and Uin) 95.2 % Static MPP efficiency 99.9 % (DIN EN 50530) Dynamic MPP efficiency 97.7 % (DIN EN 50530) Weighted REW (Realistic Equally Weighted efficiency) 92.8 % Own consumption 10 mA DC input side: MPP voltage 15 V (30 V) < Vmodule 15 V (30 V) < Vmodule < 75 V Open circuit voltage solar module 17 V ... 75 V (34 V ... 75 V) Module current 9A DC output side: Load current 10 A Reconnection voltage (LVR)* 12.5 V (25 V) Deep discharge protection (LVD)* 11.5 V (23 V) Battery side: Charge current: 10 A End of charge voltage 13.9 V (27.8 V) Boost charge voltage 14.4 V (28.8 V) Equalisation charge 14.7 V (29.4 V) Set battery type liquid Operating conditions: Ambient temperature -25 °C ... +40 °C Fitting and construction: Terminal (fine / single wire) 16 mm² / 25 mm² - AWG 6 / 4 Degree of protection IP 32 Dimensions (X x Y x Z) 187 x 153 x 68 mm Weight 900 g
Technical data at 25 °C / 77 °F
adjustable via Steca PA RC100: reconnection voltage, deep discharge protection, end of charge voltage, boost charge voltage, equalisation charge, battery type
Inverters must not be connected to the load output.
CAUTION: If an open circuit voltage of more than 75 V or 100 V is supplied to the connected solar module, the controller will be destroyed. When selecting the solar module, it is important to bear in mind that the open circuit voltage should never exceed 75 V or 100 V over the entire working temperature range. When using solar modules with a maximum open circuit voltage of between 60 and 100 V (over the entire temperature range), all installation steps must be carried in accordance with protection class II.